The suction cup is adsorbed on smooth surfaces, such as glass, mirrors, and smooth tiles; if there are small cracks or small particles on the surface, it is recommended to use auxiliary stickers.
Clean the smooth surface of the tile or the auxiliary stick before suctioning to ensure a stronger suction power.
Before use, rinse the suction cup with water and allow to dry.
The product can be used after being installed and fixed on the wall for 12 hours (this will make the suction cup stronger)
It is recommended to re-tighten the screws every 3 months to ensure higher stability.
Data such as weight are measured by hand, and there will be a little error.
Product name : Paper roll holder
material : Resin ABS
Size : 14.5 * 10CM
1: clean the tile 2: rinse the suction cup to dry the moisture
3: Press the screw 4: Clear the air
5: Screw on the knob 6: Put on the paper towel holder
The following wall installation needs to add auxiliary patches
Tiles, painted wooden doors, glass and other impermeable surfaces
Installation instructions (auxiliary patches )
1: clean and blow dry the surface, wait for it to dry
2: Tear off the protective film of the patch, and stick the adhesive side to the flat surface
3: Press with a towel to exhaust the air, so that the film fits the surface,
and the suction cup can be adsorbed to the patch.